ENDURANCE T3 VERSION 0410
ENDURANCE T3 HARDWARE ILLUSTRATION SHEET Qty. A1. M4X10 Round Cross Screw--------------------[2pcs] A1 A2. M8X16 Round Inner Hex Screw---------------[6pcs] A2 C2 C3 A3. M10X65 Round Inner Hex Screw--------------[4pcs] A3 A4. M10X90 Round Inner Hex Screw--------------[2pcs] C1. M8 (I.D)Washer----------------------------------[4pcs] C2. M10 (I.D)Washer---------------------------------[6pcs] A4 C3. M8 (I.
ENDURANCE T3 HARDWARE ILLUSTATION SHEET A[1PCS] D[1PCS] E[1PCS] F[1PCS] B[1PCS] C[1PCS] G[1PCS] PAGE 2 H[1PCS]
ENDURANCE T3 Assemble Procedures:1.B 2.C 3.D 4.E 5.F 6.OTHERS D F C3 A1 C1 A2 A2 C Do not tighten the bolts down completely during first assembly. After the completion of step 3,then you may tighten the bolts completely. Please assemble this bolt last. C2 A3 E C2 PAGE 3 A4 Please assemble this bolt last. Do not tighten the bolts down completely during first assembly. After the completion of step 3,then you may tighten the bolts completely.
ENDURANCE T3 make 3 turns After assembly and before turning power on position the rear roller using the ' T ' wrench ( refer to the drawing if needed ) .
ENDURANCE T3 TENSIONING THE BELT Running Belt If when you plant your foot on the belt , you can feel a sliping sensation then the belt has been stretched and is slipping over the roller. This is normal and common adjustment on a new treadmill. To eliminate this slipping , tighten both sides of the rear roller by wing a Allen wrench turn 1/4 of a TURN as shown above .Try the treadmill again to check for slipping. Repeat if necessary . but NEVER TURN the roller bolt more than 1/4 turn at a time.
