User's Manual

16 1716 17
REGULATORY STATEMENT
FCC Declaration of Conformity – We, BodyMedia, Inc., One Gateway Center, 420 Fort Duquesne Boulevard, Suite 1900,
Pittsburgh, PA 15222, a wholly owned subsidiary of Jawbone, declare under our sole responsibility that the products,
BodyMedia, Inc. and BodyMedia® Armband (Model AB200) and Dock (Model CR200), comply with part 15 of the FCC
rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit separate from the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this equipment not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF Exposure information: See 2.1093 of the FCC Rules
This product is a Type B Applied Part complying with the specified requirements of the Standard to provide protection
against electric shock, particularly regarding allowable Leakage Current.
IEC 60601-1, Edition 3.1, 2012-08, Medical Electrical Equipment - Part 1: General requirements for basic safety and
essential performance
IEC 60601-1-2, Third Edition, 2007-03, Medical Electrical Equipment - Part 1-2: General requirements for basic safety
and essential performance - Collateral standard: Electromagnetic compatibility - Requirements and tests
AAMI60601-1: ANSI/AAMI ES60601-1:2005, Medical Electrical Equipment – Part 1: General Requirements for Basic
Safety and Essential Performance
ANSI/IEC 60529, 2004, Degrees of Protection Provided by Enclosures (IP Code)
IEC 60950-1, Edition 2.1, 2012-05, Information Technology Equipment - Safety - Part 1: General Requirements
UL 1642, Standard for Safety, Lithium Batteries
IEC 62133, Edition 2.0, 2012, Secondary cells and batteries containing alkaline or other non-acid electrolytes - Safety
requirements for portable sealed secondary cells, and for batteries made from them, for use in portable applications
WEEE, 2006 No. 3289, Environmental Protection - The Waste Electrical and Electronic Equipment Regulations
California Energy Commission - 2012 Appliance Efficiency Regulations, CEC-400-2012-019-CMF
47CFR Part 15 Subpart B & ICES-003, Issue 4 February 2004 for Class B Digital Devices
47CFR Part 15 Subpart C 15. 247 & RSS-210, Issue 8, December 2010 for Intentional Radiators
ETSI EN 300 328 (Article 3.2 of R&TTE Directive)
ETSI EN 301 489-1 with ETSI EN 489-17 (Article 3.1(b) of R&TTE Directive)
RoHS requirements
BodyMedia, Inc.
One Gateway Center
420 Fort Duquesne Blvd.
Suite 1900
Pittsburgh, PA 15222
USA
100891_Rev1