Owner`s manual

ASSEMBLY INSTRUCTION
STEP 6
1. Install the handlebar (03) onto the bracket of
the handlebar post (01). Make sure the pulse
cable is outside the top of the handlebar
post with the computer bracket (plate)
protruded on top.
2. Put the metal cover (04) pressing the
handlebar. Then fix handlebar with one flat
washer (07), one spring washer (12), and an
Allen bolt (11) to fasten them firstly and then
assemble the plastic cover to the handlebar
by washers (7 & 12) and bushing (09) and
T-knob (10).
3. Adjust the handlebar to be a suitable angle.
Fasten the Allen bolt (11) and T-knob (10)
securely.
Precaution:
Before using this bike, be sure that you have
fastened the Allen bolt (11) and T-knob (10) on
the handlebar. This is very important
STEP 7
1. Assemble the seat (24) to the seat post
(27) with 3 nuts (26) and washers (25).
2. Insert the seat post through the bellow (28)
into the base frame through the plastic
sleeve (29). Select the ideal height position
on the seat post. Insert the knob (29) into
the hole. Tighten fully the knob.
-07-