Manual

This equipment is intended for indoor use and will meet its performance figures within the

ambient temperature range of 10°C to 35°C, with maximum relative humidity of 80% (non-

condensing). Installation Category II (transient voltages). Pollution Degree 2 in accordance

with IEC 664. Suitable for operation at altitudes of up to 6500 feet.

Specifications:

Temperature Range: ambient to 18°C below ambient, typically 4°C

Supply Voltage Range: 115V +/- 10%, 50/60 Hz

230V +/- 10%, 50/60 Hz

Power Rating: Model 260009: 110 W, 1.3 A

Model 260009-2: 110 W, 0.65A

8. Maintenance and Service

All Boekel laboratory products are designed to comply with IEC1010-1. No routine

maintenance is required.

8.1 Cleaning

Disengage power cord prior to cleaning. The outer casing may be cleaned with water and

a damp cloth. Do not submerge or immerse the MicroCooler II in water. Abrasive

materials such as paper towels may scratch the well cover or the plastic body. Do not use

solvents to clean the well cover or the plastic body. Before using any cleaning or

decontamination method, users should check that the proposed method would not damage

the equipment.

8.2 Replacement of Fuses

There are two supply fuses located in the fuse drawer. To replace the fuses:

• Disconnect the unit from the power supply.

• Remove the plug from the socket in the back of the unit.

• Pull back on the fuse drawer (see Figure 2).

• Pull out the fuse drawer.

• Check and replace with the correct fuses if necessary. The fuses must be

5mm x 20mm quick acting, rated 250V.

Model 260009: 2.0AF

Model 260009-2: 1.0AF

• Push the fuse drawer back in. Reconnect unit to the power supply.