Instructions / Assembly

4
4
5
Mount Gate to Post:
Set the gate level to the post and mark pilot holes on
the gate post. The slotted screw holes on the inside of
the post attachment allow for vertical adjustment. It is
recommended to pre-drill and install the inside screws
before installing the front screws. (6) 1
1
⁄
1
⁄
1
2
⁄2⁄
" #2 square/
phillips combo screws per hinge (3 on front of hinge and
3 on side) (Fig. 5 & 6).
NOTE:
To ensure superior gate performance for vinyl
gates, make sure gate posts use either an
aluminum gate post insert or wood blocks at both
hinge locations.
Adjust the hinge width or position to the gate post using
the four nuts located where the hinge attaches to the
rail (Fig. 7).
Fig. 5
Fig. 6
Fig. 7