Bogart TM-2030 & SC-2030 Flyer

Our website outlines installation requirements, and explains in detail each item above and
why they are useful, for both technical and less technical users.
Go to “news and updates”, “brochure information” at:
bogartengineering.com
TRIMETRIC TM-2030
BATTERY MONITOR
SC-2030 SOLAR
CHARGER
For better usage and care
—answers the important
questions about your deep
cycle batteries.
4 Is my charger still doing the job right?
4 How much energy do my lights, or the
microwave take?
4 How full are my batteries?
4 Why isn’t my system working as well as
before?
• Uses “amp hour” method of tracking “state
of charge” for better accuracy than voltage
methods.
• See instantaneous draw or charging amount
(amps or watts.)
• Compatible with any charging system or
solar controller.
• Audible low battery alarm based on Amp
hours and battery voltage.
• Minimal targeted history data for experts to
diagnose system problems.
• Shows replaced percentage of last
discharge.
• 12-48V systems. 50-10,000 amp hour
systems.
• Warranty four years.
• Manufactured in USA.
• Works to give unusually accurate Solar
charging with our new SC-2030 PWM
charger.
• Two slightly different physical styles: Surface
mount “RV” or ush mount “A”.
• Lightning resistant design.
• Requires installation of a shunt in your
battery system.
When used with the
TM-2030, it has unusual
charging features for better
solar charging.
• (“Amp hour counting”)
Provides charging based
on replacing an adjustable
percentage of previous discharge amount
to avoid undercharge or overcharge.
• (“IUI Charging”) Performs a regulated
current, higher voltage nish charge:
benecial for solar charging to safely get
more charge in the batteries during a
limited solar day.
Other benefits:
• Completely controllable from TM-2030
Monitor.
• TM-2030 shows: solar current, battery
temperature, and extra unused watts
available from solar panels in the afternoon
when batteries are not absorbing all solar
energy.
• Communicates with TM-2030 by ordinary 4
wire telephone cable.
• 31 amps max charging. OK with panels with
more amps, then limits current to less than
31A.
• All types of batteries: Wet cell, AGM, Gel.
• Optional temperature compensation
• Compact design: 5-1/4 x 3 x 2-3/4 inches
deep.
• Works “standalone” with very basic charger
functions.
• PWM type for 12-24 systems. So called
“12V” or “24V” panels should be used with
this (or any) PWM charger for maximum
efciency, for about the same efciency as
MPPT chargers, but at lower cost and
complexity.
• Download SC-2030 Solar Charger
instructions for more details.