Bogart Engineering SC-2030 Installation & User Guide

SC-2030

Solar Charge Controller

Installation and User Guide



BogartEngineering2017

www.bogartengineering.com

DOWN

TM-2030

Connected.

Charging.

Flashing = Overload

SOLAR

BATTERY

BOGART ENGINEERING

30A CHARGER

System Volts: 12V-down 24V-up

Battery Type: AGM-down Flood-up

SC-2030

Warranty:Allitemshavea3yearlimitedwarrantycoveringanyitemthatdoesnotperform

accordingtospeciﬁcaonsstatedorimpliedinourinstrucons,provideditdoesnotshow

obvioussignsofabuseormisapplicaon.Wewillreplaceorrepairanysuchitematourop-

on.AreturnauthorizaonisrequiredforallmerchandisereturnedtoBogartEngineering.

Revised04/23/2017

Use Jumpers for

Standalone

mode (only)

PAGE 1
SC-2030 Solar Charge Controller 30A CHARGER SC-2030 UP DOWN SOLAR System Volts: 12V-down 24V-up Battery Type: AGM-down Flood-up Revised 04/23/2017 www.bogartengineering.com Bogart Engineering 2017 Use Jumpers for Standalone mode (only) Warranty: All items have a 3 year limited warranty covering any item that does not perform according to specifica ons stated or implied in our instruc ons, provided it does not show obvious signs of abuse or misapplica on.
PAGE 2
SC-2030 Installation Solar Crossover Modular Cable to SC-2030 or serial data connection Solar panels “12” or “24 volt” types (36 or 72 cells per panel) + - Illustra on By R.
PAGE 3
Programming the TM-2030 when using the SC-2030 Programming Instructions for the TM-2030: http://www.bogartengineering.com/wp-content/uploads/docs/EnterP1Data.pdf The SC-2030 will operate as a standalone charger with minimal function unless connected to the TM-2030. Visit our website for more information The following settings apply only when using the SC-2030 Solar Charge controller with the TriMetric monitor. P8-P22 are accessible only when Program P7 is set to L3 or L4.