TM-2030 Quick Reference

AMPS
Hold SELECT 3
seconds to view
VOLTS
% FULL
B2
B1
when flashing-meets "CHARGED" criteria
AMP-HOURS FROM "FULL"............RESET: to 0 Amp-hours
DAYS SINCE "CHARGED"................RESET: to 0 days
DAYS SINCE EQUALIZED................RESET: to 0 days
REPLACED PERCENTAGE FROM LAST DISCHARGE
=AMPS or =WATTS
SELECT
RESET
Operating and programming instructions at
www.bogartengineering.com/ins
TM 2030-RV
Bogart Engineering
CHARGING
BATTERY
REMINDERS
=TIME TO CHARGE
=TIME TO EQUALIZE
=BATT. VOLTS LOW
Push quickly to make display toggle through:“SELECT”
DO YOU PREFER “AMPS” OR “WATTS” to show
in primary display?
See User’s manual, Table 2, Program P4, to change.
TO ACCESS PRIMARY (MOST OFTEN USED) DISPLAYS
More description: section 1, next page
See TM-2030 User’s manual section 2.2 for details
Lamp flashes and display occasionally shows these letters
when: battery should be “ ”
or “battery should be ” “ ”
or “battery ” “ ”
fully charged Ch.F
equalized Ch.E
voltage low b.LO
Optional: BATTERY REMINDERS:
Push and hold for 3 seconds until " " pops into display.
Immediately release . Now push to step through the 5
items shown here.
SELECT AH
SELECT SELECT
Descriptions section 2.1 next page
TO ACCESS SECONDARY (LESS OFTEN USED) DISPLAYS ITEMS:
IMPORTANT DISPLAY NOTE: Flashing decimal
point means “multiply the number seen by 1000”
The button will reset any of the following:
“Batt% full” (to 100%)
Amp Hours from full (to 0 Ahr)
Days since charged (to 0 days)
Days since equalized (to 0 days)
(1) Use SELECT to view it on
display. (2) Push and hold RESET for 5 seconds.
RESET
To RESET any of these:
TO ACCESS PROGRAM OR HISTORY DATA
NOT SURE WHERE YOU ARE?
: Hold
down and watch for “ ” (Program) or “ ”(History) at left in display,
then release . See sections 2.2 for details on
data. See sections 2.2.3 on data.
Push SELECT repeatedly
until you get back home.
SELECT
PH
SELECT program
history
TM-2030 controls and display
VOLTS
AMPS WATTS
(first battery B2, then battery B1)
(or ) charging(+) or discharging (-) battery B1
%FULL (for battery 1) Battery B1 must be charged fully
at least once before this will display.
Battery charge information, battery charging rate control
Temperature, solar current into battery
Bogart Engineering
Quick reference guide to TM-2030 Battery Monitor
with or without SC-2030 Solar Charger
This page revised: June 15, 2015
SC-2030
Solar Charger
TM-2030
Battery Monitor
When light , means “battery 1 is ”
(“amps” or “watts” is positive)
on charging
When battery
(see TM-2030 instructions, sec 6.2, A).
Flashing: now meets charged criteria:
Except when Program P7, level 4 selected:
Battery met charged criteria--and still > 97% full.
CHARGING LIGHT