MPS1 Mini Pendant Speaker Models MPS1B /MPS1W Installation and Use Manual © 2010 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice.
Power Tap Selection POWER TAP SELECTOR SWITCH 16-ohm or 70V The Power Tap selector switch is used to set the appropriate power level or impedance for your system. Rotate the switch until the power level you require lines up with arrow. IMPORTANT: When connecting to a 70V amplifier, make sure that the MPS1 Tap Selector switch IS NOT set in the “16Ω” position. MPS1 (Top View) Speaker Connection and Polarity Speaker wiring is terminated at a snap-lock input connector, with a positive and negative terminal.
MPS1 Speaker Cable Connections and Suspension Instructions In addition to the Main suspension Drop Cable, a backup Safety Cable is required for proper installation. Use wire rope or other drop line rated for at least 100 lbs. to ensure a safety margin. The attachment point on the structure from which the speaker is to be anchored also must be able to handle 100 lbs.
Technical Specifications Frequency Response (-10dB)* 50Hz to 14kHz Driver Complement 4-1/2” Dual-Cone Wide-Range Sensitivity (1W/1m) 85dB (Average 100Hz – 10kHz) Impedance Range Power Input (Maximum) Power Settings (in watts)** Enclosure Material Low (16 Ohms) / High (70V) 50W @ 16 Ohms; 32W @ 70V 70V: 32, 16, 8, 4, 2, 1 ABS Plastic Injection-Molded Grille Material Powder-Coated Perforated Steel Terminations 2 Terminal Quick-Disconnect Connector Product Weight 4 lb. 8 oz.