Model UHF8011BP/HH UHF PLL SINGLE CHANNEL DIVERSITY WIRELESS SYSTEM INSTRUCTION MANUAL UBP8011 UHF PLL TRANSMITTER UDR8011 CHANNEL SINGLE UHF PLL RECEIVER DIVERSITY UHF8011BP/HH www.bogen.com ©2019 Bogen Communications, Inc. Specifications are subject to change.
INSIDE FRONT PAGE INTENTIONALLY LEFT BLANK
TABLE OF CONTENTS 1. Notes for System Operation 1 2. Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 3. Model Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 3-1 UDR8011 UHF PLL Single Channel Diversity Receiver . . . . . . . . . . . . . 2 3-2 UHT8011 UHF PLL Hand Held Transmitter . . . . . . . . . . . . . . . . . . . ...... . 3 3-3 UBP8011 UHF PLL Body Pack Transmitter . . . . . . . . . . . . . . . ..... . . . . . .
1. Notes for System Operation • Before connecting the power, check that the power requirement shown on the unit is the same as the power output on the adapter supplied. • Do not operate the unit where humidity and temperature are high. • Dry your hands before operating the system. • Keep the unit away from fire and heat source. • Turn the volume to minimum on both the mixer and amplifier before setting up and powering on the system. 2. Features • Six groups are provided as default.
3. Model Specifications 3-1 UDR8011 UHF PLL Single/Dual Channel Diversity Receiver MODEL UDR8011 Frequency Mode Phase-locked loop (PLL) Frequency Range 470 ~ 960 MHz Sync Frequency Ultrasonic Bandwidth 36 MHz Signal/Noise Ratio Total Harmonic Distortion (Thd) Receiving Sensitivity > 105 dB(A) < 0.
MODEL UHT8011 Frequency Mode Phase-locked loop (PLL) Frequency Range 470 ~ 960 MHz Sync Frequency Ultrasonic 3-2 UHT8011 UHF PLL Hand Held Transmitter Microphone RF Power Output MODEL RF Stability Frequency Mode Modulation Frequency Frequency Range Harmonic Radiation Sync Frequency Display RF Power Output Controls RF Stability Functions Modulation Frequency Harmonic Radiation Battery Display Charging Controls Dimensions Functions Battery 10m W / 50m W (as per local regulations) UHT8011 < ± 10 kHz
MODEL BCLM1 Connector 4P Mini XLR Frequency Response 3-4 BCLM1 Polar Pattern Sensitivity MODEL (at 1000Hz) Impedance Connector Max. SPL for 1% THD Frequency Response Dimensions Polar Pattern Net Weight(at 1000Hz) Sensitivity Impedance *0dB = 10V/pa Max. SPL for 1% THD 100 ~ 15,000 Hz Lavalier Microphone Cardioid -60 ± 3 dB*1 BCLM Ω 4P 2.2k Mini XLR 130 dB 100 ~ 15,000 Hz Ø 0.39” (W) x 1” (H) Cardioid 0.75 -60 ± 3oz. dB* 2.2k Ω 130 dB Dimensions Ø 0.39” (W) x 1” (H) Net Weight 0.75 oz.
4. Description of Parts 4-1 UDR8011 Receiver Feature Callouts - Front View 8 UDR8011 4 7 3 UHF PLL SINGLE CHANNEL DIVERSITY RECEIVER 6 5 2 1 1 POWER: = ON and 2 SET: Push and hold for 2 seconds to enter the Setting Mode. Push SET to advance to the next parameter. 3 ▲/▼: In the Setting Mode, push ▲/▼ to change the parameter value. In the non-Setting Mode: push ▲/▼ to adjust audio output volume. = OFF 4 LCD Display: System Information (see page 7 for features).
4-2 UDR8011 Receiver Feature Callouts - Rear View 3 2 9 1 10 11 9 13 12 y 9 RECEIVING ANTENNA: BNC connection for 1/2 antenna. 10 PHONE JACK (1/4” TS): Unbalanced audio output jack. 11 3P XLR MALE: Balanced audio output jack. 12 STRAIN RELIEF: Securement for DC power cable. 13 DC POWER SOCKET: 12-15 VDC / 300mA power supply.
4-3 UDR8011 Receiver LCD Display 3 25 4 26 8 30 2 24 1 23 5 27 10 32 5 27 7 29 9 31 6 28 Shown above in the non-Setting Mode 1 : Audio Signal strength 2 : RF Signal strength 3 : Antenna A or B active 4 : Transmitter Battery Level 5 7 / : Group/Channel 6 : Volume Output 7 : Button Lock 8 : Receiver/Transmitter Mute 9 : Output Attenuation 10 : Frequency
4-4 UHT8011 Hand Held Transmitter Feature Callouts UHT8011 2 3 4 6 7 8 10 1 5 9 11 1 REMOVABLE HANDLE COVER: Unscrew to access controls and batteries. 2 LCD DISPLAY: Displays the parameter settings in the transmitter. 3 4 5 6 LED INDICATOR: Displays the transmitter’s status, including battery level, mute and pairing indication. : Push and hold button for 2 seconds to lock the buttons/controls. Push and hold again for 2 seconds to unlock. POWER: Push to turn the transmitter on.
4-5 UBP8011 Body Pack Transmitter Feature Callouts 5 74 1 72 6 71 TOP VIEW REAR VIEW FRONT VIEW 7 73 75 2 3 70 UBP8011 UHF PLL TRANSMITTER 10 78 BOTTOM VIEW 9 76 4 79 1 LED INDICATOR: Indicates the transmitter’s status, including battery level, mute and pairing indication. 2 MICROPHONE INPUT PORT: 4P mini XLR jack 3 MUTE/POWER: Push once to turn the unit on. While the unit is on, push once to mute and push again to unmute. Push and hold for 2 seconds to turn off.
3 84 4 84 4-6 BCLM1 Condenser Lavalier Microphone (Standard with UBP8011) 1 MIC CLIP 2 MICROPHONE 3 WINDSCREEN 4 4-PIN MINI XLR 1 82 2 1 84 82 BCLM1 2 84 BCLM1 1 82 3 84 3 84 4 84 4 84 4-7 UHFHSMB Headset Microphone (optional for UBP8011) 1 1 82 ADJUSTABLE HEADBAND 2 GOOSENECK 3 MICROPHONE 4 WINDSCREEN 5 4-PIN MINI XLR 1 82 2 84 4 84 3 84 5 84 2 84 4 84 5 84 5 84 2 84 4 84 3 84 3 84 4-8 Included Accessories 1 1 2 AC/DC ADAPTOR (UDR8011-RPS): AC IN: AC100~240V, 50/60Hz
5. Connecting 5-1 How to Connect the UDR8011 Receiver 1. Connect the audio output of receiver to mixer or amplifier 1.1 UDR8011 Receiver The XLR balanced output jack or 1/4” unbalanced output jack can be used to connect the audio output to a mixer or an amplifier. 2. Connect the Power 2.1. Connect the AC/DC adapter: Check that the DC current and voltage ratings of the adapter match the label on the unit. Connect the DC terminal to the DC input port on the unit and the AC end to an AC outlet. 2.2.
5-2 Transmitter Installation 1. UHT8011 Hand Held Transmitter 1. Unscrew the outer tube of the transmitter (Fig. 1). 2. Open panel door and place 2 AA batteries in the battery holder, ensuring they are in the correct polarities (Fig. 2). 3. Screw the outer tube on (Fig. 3). 4. To turn the unit on: a. Push the Power button to turn the unit on (Fig. 4a), or b. Push the Mute switch up to turn the unit on (Fig. 4b). 5. Set the transmitter parameters according to the instructions (section 6-2). Fig. 1 Fig.
6. Instructions for Use 6-1 UDR8011 Receiver 1. Parameter Setting Push and hold the SET button to enter the Setting mode. Push the ▲/▼ button to select parameter. Push SET again to advance to the next parameter. UBP8011 When RX receiver is selected: UHF PLL TRANSMITTER UDR8011 UHF PLL SINGLE CHANNEL DIVERSITY RECEIVER ◎ GROUP: Group / Channel G: group Select default group 1~6 CH: channel Select default channel, 1~22 (max.
When TX transmitter is selected: ◎ ATT: Microphone Audio Input Attenuation At oFF No attenuation. At on 20 dB attenuation at audio input). The function is activated with 20 dB of audio input attenuation. ◎ GAIN: Microphone Input Sensitivity High Sensitivity Default Low Sensitivity GAIN: +15 dB GAIN: +12 dB GAIN: +9 dB GAIN: +6 dB GAIN: +3 dB GAIN: 0 dB GAIN: -3 dB GAIN: -6 dB GAIN: -9 dB GAIN: -12 dB GAIN: -15 dB Shows the microphone input sensitivity is now at 0 dB (default setting).
2. Volume Adjustment In non-Setting Mode, adjust the volume from 0 to -31 dB using the ▲/▼button. • The minimum volume is -31 dB. • The maximum volume is 0 dB. • The default setting is -10 dB. Note: This Volume affects the balanced and unbalanced outputs Minimum volume at -31 db; maximum volume at 0dB 3. Sync Pairing Once the parameters are set, push the SYNC button and the digital pairing data will be sent to the transmitter via ultrasonic transmission for parameter synchronization.
6-2 UHT8011 Hand Held Transmitter and the UBP8011 Body Pack Transmitter 1. Parameter Setting Push and hold the SET button to enter the Setting mode. Push the ▲/▼ button to select parameter. Push SET again to advance to the next parameter. UDR8011 UBP8011 UHF PLL TRANSMITTER UDR8011 UHF PLL SINGLE CHANNEL DIVERSITY RECEIVER UHT8011 UHF PLL SINGLE CHANNEL DIVERSITY RECEIVER UBP8011 ◎ GROUP: Group / Channel G: group Select default group 1~6 CH: channel Select default channel, 1~22 max.
UHT8011 UBP8011 ◎ ATT: Microphone Audio Input Attenuation At oFF No attenuation. At on 20 dB attenuation at audio input). Audio input attenuation at 20 dB. ◎ RFP: RF Transmitter Power rFP Lo 10mW rFP Hi 50mW The RF output is LO. The RF output is Hi. ◎ ATOF: Automatic Turn Off Timer OFF This function is deactivated. 1 1 minute shutdown. 10 10 minute shutdown. 30 30 minute shutdown.
7. Additional Product Instructions 1. For the best Sync results, always keep the UHT8011/UBP8011 transmitter within 12-inches of the UDR8011 receiver with Line of Sight. 2. The UDR8011 receiver and UHT8011/UBP8011 transmitter must be away from other metal objects, preferably 20-inches or farther. 3. It is recommended to hold the UHT8011 transmitter (microphone) at the mid-section for the best signal. 4.
8.
9. Product Warranty Limited Warranty: Exclusion of Certain Damages The Bogen UHF Wireless Systems (UHF8011-BP/HH) are warranted to be free from defects in material and workmanship for one (1) year from the date of sale to the original purchaser.
UHF8011BP/HH UHF PLL SINGLE CHANNEL DIVERSITY WIRELESS SYSTEM UBP8011 UHF PLL TRANSMITTER UDR8011 UHT8011 UHF PLL SINGLE CHANNEL DIVERSITY RECEIVER UDR8011 www.bogen.