User's Manual

13
6. Instructions for Use
6-1 UDR8011 Receiver
1. Parameter Setting
Push and hold the SET button to enter the
Setting mode. Push the ▲/▼ button to select
parameter. Push SET again to advance to
the next parameter.
When RX receiver is selected:
◎ FREQ: Frequency Setting
In 1 MHz Select frequency with ▲/▼
In 0.025MHz Select frequency with ▲/▼
Select the number of frequency rst
in MHz and then in 0.025 MHz.
◎ SCAN: Channel Scan
SC oFF
CH: Channel will increment sequentially.
SC on
CH: Channel will scan for the next avail-
able channel, avoiding interference.
This function is deactivated.
UHF PLL TRANSMITTER
UBP 8011
UDR 8011
UHF PLL SINGLE CHANNEL
DIVERSITY RECEIVER
The default setting is 0.
◎ ATT: Audio Output Attenuation (XLR)
At oFF
No attenuation at audio output
At on
20 dB attenuation at audio
ouput
This function is deactivated.
◎ SQ: Squelch Sensitivity
-5~+10dB -5 is the maximum sensitivity.
+10 is the minimum sensitivity.
The default setting is 0.
◎ GROUP: Group / Channel
G: group
Select default group 1~6
CH: channel
Select default channel, 1~22 (max.)
Select the group when G is ashing;
select the channel when CH is ashing.
Note: When Channel Scan is ON, ▲/▼ will scan
for the next available channel.