AMT-12 AMT-15 Professional Loudspeakers Installation and Use Manual © 2008 Bogen Communications, Inc. Specifications subject to change without notice.
Table of Contents Introduction 2 Speaker Mounting 2 Powering the Loudspeaker 3 Input Panel 3 Daisy-Chaining Speakers 4 Speaker Block Diagram 4 Connector Wiring Diagram 4 Specifications 5 Limited Warranty 6 Notice Every effort was made to ensure that the information in this guide was complete and accurate at the time of printing. However, information is subject to change.
Introduction The AMT-12 is designed to deliver high-output music and sound reinforcement in a lightweight package. The 12-inch woofer has high sensitivity to maximize amplifier output. The 1.77-inch compression driver diaphragm, comprised of an titanium-alloy for added strength and rigidity, effortlessly handles the high input levels to match the woofer. A carefully designed cross-over network accurately filters each driver for proper matching of phase and summation in the cross-over region.
Powering the Loudspeaker Amplifier Selection It is important that the appropriate amplifier be used for a specific loudspeaker to avoid accidental driver damage. Underpowered amplifiers will clip easily, sending a highly distorted signal to the speaker. This distorted signal has a far greater density of energy than normal program and will “burn out” drivers quickly. Note: Be certain that the total impedance of all interconnected speakers is not lower than the amplifier’s minimum rated impedance.
Example A Daisy-Chaining Speakers In these examples, pins 1+ and 1- on the Input (Left) connector receive full-range audio from the amplifier or from a previous speaker in a chain. AMPLIFIER The Parallel Input (Right) connector uses the 1+ and 1- pins to send full-range audio to the Input connector of another speaker in a chain. Loop-Thru connects all speakers in the chain in parallel. Make sure the total impedance of the chain is not less than what the amplifier is rated to handle.
AMT-Series Loudspeaker Specifications SPECIFICATIONS AMT-12 Frequency Response (-10 dB)* 60 Hz to 20 kHz LF Driver 12" High-Sensitivity Design HF Driver 1.77" Titanium-Alloy Diaphragm Compression Driver Sensitivity (1W/1m) 96 dBspl Impedance Ratings 8 ohms Nominal Power Input (Max.
Limited Warranty; Exclusion of Certain Damages Apogee Sound AMT-12 and AMT-15 Loudspeakers are warranted to be free from defects in material or workmanship for three (3) years from the date of sale to the original purchaser.
50 Spring Street, Ramsey, New Jersey 07446, USA 201-934-8500 • Fax: 201-934-9832 www.apogeesound.