User Manual

ManualsBrandsBogen ManualsSpeakerASWG1

Amplified Speakers

Models AS1, ASUG1(DK), and ASWG1(DK)

Installation and Use Manual

Description

Bogen’s self-amplified ceiling speakers are 8-inch, cone-type loudspeakers, complete with built-in amplifier and volume

control knob.

Installation Instructions for ASUG1(DK) and ASWG1(DK)

Note: Do not mount the speaker near noise generating equipment (fans, motors, etc.) and do not use where a normal

conversation cannot be conducted.

TB8 and RE84 Installation

1. Place ceiling tile with the finished side facing up over a large

trash can (to provide support and save cleanup time).

2. Cut hole in the center of the ceiling tile, using the raw speaker

as a guide.

3. Bend (4) horseshoe tabs upward on tile bridge.

4. Position the tile bridge on the unfinished side of the ceiling tile

and bend (4) locator tabs into tile opening to prevent sliding.

5. Slip tie-off tabs (2) through RE84 tie-off tab slots until they click

into place and secure customer-supplied “tie-off” wire to tab.

6. Punch out knockout in the RE84. Install listed metallic enclo-

sure entry fitting to knockout to accommodate plenum cable or

plenum. Whip and feed cable or whip through the knockout.

7. Install RE84 to tile bridge by orienting horseshoe tab slots (4)

over horseshoe tabs (4) of bridge.

8. With pliers, twist horseshoe tabs (4) of tile bridge 1/2 turn,

securing enclosure to bridge.

9. Screw the Ceiling Speaker assembly to the RE84 using (4)

8-32 screws provided with the Ceiling Speaker assembly,

sandwiching the TB8 and ceiling tile in between. The screws

must go through the TB8 clearance holes as shown. (Screws

anchor into the RE84.)

Model Style

Power

Requirements

Power

Rating

Mounting Accessories

AS1

Unmounted Cone Speaker with 1W Amplifier and

Volume Control

1 CU

(50 mA)

Grilles: SG8W, PG8U, PG8W

ASUG1,

ASWG1

AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)

with Fixed, Volume Control Knob

TB8, RE84, MR8

ASUG1DK,

ASWG1DK

AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)

& Detachable Volume Control Knob

Specifications subject to change without notice.

54-5850-02E 1210

Summary of content (2 pages)

PAGE 1
Amplified Speakers Models AS1, ASUG1(DK), and ASWG1(DK) Installation and Use Manual Description Bogen’s self-amplified ceiling speakers are 8-inch, cone-type loudspeakers, complete with built-in amplifier and volume control knob.
PAGE 2
TB8 Only Installation 1. Place ceiling tile with the finished side facing up over a large trash can (to provide support and save cleanup time). 2. Cut hole in the center of the ceiling tile, using the raw speaker as a guide. 3. Position the tile bridge on the unfinished side of the ceiling tile and bend (4) locator tabs into tile opening to prevent sliding. 4. Install Ceiling Speaker assembly using (4) 8-32 screws and the threaded holes of the tile bridge as shown.