Manual Wall-Mount Power Vector Amplifiers Installation And Use Manual

Connections

COM and GND Terminals

A shorting jumper typically connects the COM and GND terminals of the

amplifier together. The COM terminal is a common lead from the output

transformer. For the transformer-coupled speaker output to work, one of the

speaker load leads must be connected to this terminal.The GND terminal is

a connection to the system’s electrical ground and used when driving loads in

the Direct Out mode.

Connecting the GND to the COM terminal when using the transformer-cou-

pled outputs references the transformer output to ground. Disconnecting the

GND terminal from COM allows the transformer output to float electrically.

This is sometimes useful under certain conditions where a ground connection

is undesirable. It is generally a good idea, however, to short the GND to the

COM terminal regardless of output type (Trans or Direct).

Remote Volume Control

These terminals are provided for remote control of the Master Volume con-

trol.This control is motorized, allowing full control over the setting of the

master volume. The Bogen Remote Volume Control Panel (model RVCP)

provides a simple and elegant means of remote control. Shorting the UP ter-

minal with the C terminal will rotate the Master Volume control in a clock-

wise direction, increasing the volume level. Shorting the DN terminal to the

C terminal will cause the Master Volume control to rotate in a counter-

clockwise direction and decrease the level of the Master Volume control.The

impedance of the shorting connections must be less than 100 ohms in order

to operate the control.

Mute Control

Each priority bus (High, Medium, and Low) can be externally activated.This

allows priority buses of two or more Wall-Mount Power Vector units to be

linked together for system expansion purposes. A particular mute

priority can be externally forced by shorting that priority’s bus terminal to

the C terminal of the Mute Control (the C terminal is the system ground).

Forcing the H priority bus this way will mute all modules except for modules

set for priority level 1 (highest priority). Forcing the M priority bus will mute

modules set for priority levels 3 or 4, but not levels 1 or 2, and forcing the

L priority bus will only mute modules set at priority level 4. See System

Expansion of Power Vector Amplifiers section and illustration on page 8.

Bridging Mix Bus

This connector makes the Wall-Mount Power Vector’s mix bus available exter-

nally and allows the connecting of Power Vector units for system expansion

and simple room combining.

This function is bi-directional. Any signal received will be amplified and any

signal sent can be used by another Power Vector amp.The signal levels at the

bridging jack will drop by one-half with two Power Vectors tied together and

by two-thirds with three units tied together. Because of the attenuation of the

bridging signal, due to the signal loading of other Power Vectors, it is not

recommended that more than three units be connected together. See Mute

Control section and the illustration on the next page for additional information.