Operating instructions

Operation
GMS810-/GMS811-FIDOR · Operating Instructions · 8013911 V1-0 · © SICK AG 53
Subject to change without notice
5.2.9 Factory setting
Menu: FIDOR/Factory setting
5.2.9.1 Device information
Menu: FIDOR/Factory setting/Device information
This menu contains general device information.
5.2.9.2 Options
Menu: FIDOR/Factory setting/Options
Menu item Significance
Serial number Serial number.
Location Name of measuring location.
ID Internal identification number.
Version Version number.
SOPAS SOPAS version.
FW Firmware version.
Menu item Significance
Line voltage Shows the mains voltage set on the FIDOR.
If the shown voltage is not identical with the available mains voltage: Please con-
tact SICK Customer Service.
Power Shows how the heating is set (fixed).
–Catalyst
–Line
– Not used
Selection of connected heating: Catalyst, heated line or none.
Int. ready Setting whether internal signal is to be evaluated.
Yes: Internal available.
No: No signal evaluation.
Ext.ready External signal (input):
Yes: Signal evaluation.
No: No signal evaluation.
E.maint.req. External signal (input):
Yes: Signal evaluation.
No: No signal evaluation.
Ext.failure External signal (input):
Yes: Signal evaluation.
No: No signal evaluation.
MMode=MReq Setting: When device is in Maintenance mode:
Should a maintenance request be generated (Yes/No).
Pr. adaption For pressure adaption: Please contact SICK Customer Service.
.4.6
 p. 53, §5.2.9.1
 p. 53, §5.2.9.2
 p. 54, §5.2.9.3
FIDOR:MEASURING
Back
Enter
1 Device information
7 Options
8 Heated line
Factory setting
.\FIDOR