User Manual

Easy Design

Speaker

Model CS1EZ

Speaker Layout

The layout of the speakers should be planned before installation

begins. Layout starts in one corner of the room. The first speaker

should be positioned from each wall a distance approximately

equal to the ceiling height of the room.

The next speaker in row 1 should be spaced a distance approxi-

mately equal to twice the height of the ceiling. Each additional

speaker in the row should use this same spacing.

Row 2 starts at twice the ceiling height distance from row 1 and

twice the ceiling height from the wall. The other speakers in this

row are also spaced at twice the ceiling height.

Row 3 is again spaced at twice the ceiling height from the previ-

ous row. The first speaker starting this row is positioned at one

ceiling height distance from the wall (similar to row 1).

Continue this pattern of alternating rows until the room is covered.

The spacing of the speakers can be adjusted so that the speakers

are evenly spaced in a row and aesthetically pleasing.

TB8 Tile Bridge - The TB8 supports the weight of the

speaker and recessed enclosure. This is also the item

to which the speaker mounting screws attach. The TB8

is required for each speaker assembly installed.

TB8

Tile Bridge

RE84

Recessed

Enclosure

RE84 Recessed Enclosure - The RE84 is an optional back

box for ceiling speakers. UL Listed for use where ceiling

plenum is part of an air handling system. The RE84 also

includes attachment tabs allowing the enclosure to be sup-

ported from structures other than the actual ceiling grid.

Additional Hardware

54-5043-01C 1209

Specifications subject to change without notice.

PAGE 1
TM Easy Design Speaker Model CS1EZ Speaker Layout The layout of the speakers should be planned before installation begins. Layout starts in one corner of the room. The first speaker should be positioned from each wall a distance approximately equal to the ceiling height of the room. The next speaker in row 1 should be spaced a distance approximately equal to twice the height of the ceiling. Each additional speaker in the row should use this same spacing.
PAGE 2
Speaker Installation STEP 4a - If not using RE84 Recessed Enclosure: Make the electrical connections using the 2 screw terminals on the CS1EZ. The suggested amplifier connections are: STEP 1 - Remove the tile from ceiling and center the TB8 tile bridge on the back. Use the tile bridge to trace out, and then cut an 8-1/2” square hole.