Installation Manual

6
Installation
Package Contents
• Digital Feedback Terminator Unit
• Power Pack, 12V DC
• Package of two
1
/2" mounting wood screws
• Installation Manual
You can mount the Digital Feedback Terminator on a wall, rack or table.
Installation Steps
These are the general steps for installation:
1. Mount the unit to the wall, rack or table.
2. Make cable connections from the DFT120 to the PBX and the paging system.
3. Set DIP switches to the desired operation.
4. Power unit up.
5. Test unit operation.
Mounting the Unit
To mount the unit:
1. Select a space on the wall, rack or table. Make sure there is a standard electrical outlet into which you
can plug your power pack. This outlet should not be controlled by a switch.
2. Mount the DFT120 and its wiring at least 18 inches away from power supply or other equipment that
generate electrical noise. Secure using the supplied mounting screws.
3. Connect the power supply. Power LED should be green.