Owners manual

Output Connections

WMT1A (Rear Panel; #2)

This RCA output jack, when used with a Bogen WMT1A Line-Matching

Transformer accessory provides a 600-ohm output to feed a remote

amplifier or a telephone line. Refer to the instructions provided with the

WMT1A accessory for connection information.

Note: Shorting clip between GND/COM on the speaker output

terminals strip must be installed to use this feature.

To Power Amp (Rear Panel; #3)

The Gold Seal Series amplifier may be used to drive an external power am-

plifier (can only be used with unbalanced high-impedance inputs).

Note: Shorting clip between GND/COM on the speaker output

terminal strip must be installed to use this feature.

Pre-Out/Power In Jacks (Rear Panel; #12, #13, #14)

These jacks permit the insertion of signal processing equipment into the

signal path between the preamp output and the power amp input. The

LINK switch should be in the IN position for normal operation. When using

external signal processing equipment, place the switch in the OUT posi-

tion and connect PRE OUT to the signal processing equipment’s input.

Connect the POWER IN to the signal processing equipment’s output.

Note: Ensure that the LINK switch is in the IN position when NOT

using external signal processing equipment, otherwise there

will be no output from the amplifier.

Tape Out (Rear Panel; #15)

The TAPE OUT jack provides a line-level output to feed a recording

device. The output is not effected by the Master volume control or EQ,

however, the output is affected by the microphone inputs’ Lo-Cut filter.

Output Terminal Strip (Rear Panel; #1)

Speaker systems are connected directly to the speaker output terminals

on the rear panel. Connect one speaker lead to the COM terminal and the

other to the terminal corresponding to the impedance of the speaker

system. Select only one of the output types.

For ALL

ground-referenced output operations (unbalanced systems),

install a shorting clip (18 AWG solid wire jumper) between COM and

GND. Installing this shorting clip will also reduce the potential for the

amplifier going into protection when the input signals and/or the gain set

are too high.

For special applications only

that require floating outputs (i.e., balanced

systems), do not install a shorting clip between COM and GND.

Note: If GND/COM shorting clip is not installed, the WMT1A

and “TO PWR AMP” outputs will not operate.

CLASS 2 WIRING SHALL BE USED

Shorting Clip: 18 AWG solid wire jumper