MPS1, MPS2 Mini Pendant Speakers Models MPS1B /MPS2B (Black), MPS1W / MPS2W (White) Installation and Use Manual © 2010 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice.
Power Tap Selection POWER TAP SELECTOR SWITCH 16-ohm or 70V The Power Tap selector switch is used to set the appropriate power level or impedance for your system. Rotate the switch until the power level you require lines up with arrow. IMPORTANT: When connecting to a 70V amplifier, make sure that the Tap Selector switch on the speaker IS NOT set in the “16Ω” position.
MPS1/2 Speaker Cable Connections and Suspension Instructions In addition to the Main suspension Drop Cable, a backup Safety Cable is required for proper installation. Use wire rope or other drop line rated for at least 100 lbs. to ensure a proper safety margin. The attachment point on the structure from which the speaker is to be anchored also must be able to handle 100 lbs.
Technical Specifications Frequency Response (-10dB)* MPS1: 50Hz to 14kHz; MPS2: 50Hz to 22kHz Driver Complement MPS1: 4-1/2” Dual-Cone Wide-Range; MPS2: 4-1/2” Woofer, 3/4" Coaxial Tweeter Sensitivity (1W/1m) MPS1: 86dB (Average 100Hz to 10kHz); MPS2: 87dB (Average 100Hz to 15kHz) Dispersion Impedance Range Power Input (Maximum) Power Settings (in watts)** Enclosure Material 140 degrees Low (16 Ohms) / High (70V) 50W @ 16 Ohms; 32W @ 70V 70V; 32, 16, 8, 4, 2, 1 ABS Plastic Injection-Molded Grille Ma
