Specifications

CONFIGURATION 13:

EMERGENCY ALERT TONES

Emergency Alert Tones is a non-programmable feature that lets the caller take priority over all paging functions and send an emergency

alert tone to all speakers. In addition to the PCM2000 modules, this option requires a Bogen VMIX (8-channel mixer/pre-amplifier),

an input/output module RIO1S, and a Tone Generator module TNG1S.

INSTALLATION:

STEP 1: Assemble Modules PCMTIM to PCMCPU and to PCMZPM (see Illustration/Instructions on Appendix page 37,

then return to this page and complete the following Steps).

Note: DO NOT

connect the PCMPS2 (power supply) at this point.

STEP 2: Connecting the Paging Amplifier

• Locate the terminals on the PCMCPU module labeled PA IN/RT and wire to the TIP and Ring (T & R) input on the Bogen

paging amplifier (either TPU-Series, GS-Series, or Classic Series amplifiers).

• Locate the terminals on the PCMCPU module labeled PA OUT/RT and wire to COMMON and either the 25 or 70V output

on the paging amplifier.

STEP 3: Connecting Optional Equipment

• Insert a RIO1S module into Slot 7 or 8 of the VMIX, and insert the TNG1S into one of the other slots (1 thru 6).

• Connect a 6-conductor cable between RJ11 modular jack on the RIO1S and the OVER RIDE input on the PCMTIM.

• Any selected tone on the tone generator module TNG1S can be activated using a dry contact closure (relay, switch, etc.).

STEP 4: Switch and Control Settings

• Refer to paging access modules described previously. See instructions described in the first bullet within STEP 3 on page 5 if using

Page Port Contact Closure; page 7 for Page Port VOX; page 9 for Loop Start Trunk; page 11 for Ground Start Trunk; or page 13 for

Station Level/Centrex. Then return to this page to complete the following Step.

STEP 5: Testing Your System

• Connect the power supply PCMPS2 to the PCMCPU module to either the power jack 12V DC input or wire it to the 12V DC screw

terminals, observing polarity.

• Connect the Bogen amplifier to the AC power outlet (120V AC 60Hz).

• Set the volume on your Bogen amplifier to a half turn.

• Press the normally open customer supplied switch once and listen for the emergency tones.