Specifications

30
CONFIGURATION 14:
SINGLE AMPLIFIER BACKGROUND MUSIC LINE-LEVEL SIGNAL
Single amplifier BGM operation is a programmable feature that lets the PCM2000 use the paging amplifier to provide high-power BGM
to the 25/70V AC speakers when the paging system is idle.
INSTALLATION:
STEP 1: Connecting Telephone System Paging Output to the PCMTIM
• Refer to paging access modes described previously in STEP 2 on page 5 (Paging Port/Contact Closure); page 7 (Page Port/VOX);
page 9 (Loop Start Trunk); page 11 (Ground Start Trunk); or page 13 (Station Level/Centrex). Then return to this page to complete
the following Steps.
STEP 2: Connecting the BGM Source
• Connect the BGM source output to the PCMTIM module terminals labeled BGM SRC/RT.
STEP 3: PCMCPU Switch Settings
• Remove the switch lock on the PCMCPU module and place the PROGRAM/RUN switch to the PROGRAM position (down), the
green LED will illuminate.
• Refer to Switch setting described previously in STEP 3 on page 5 (Paging Port/Contact Closure); page 7 (Page Port/VOX);
page 9 (Loop Start Trunk); page 11 (Ground Start Trunk); or page 13 (Station Level/Centrex). Then return to this page to
complete the following Steps.
STEP 4: Activating the Background Music
• Access the PCM2000 system (either use a single 2500-series line telephone or butt set or dial the paging access number from the
telephone system). You will hear 3 beep tones indicating access to the programming mode.
• Dial 019 follow by the ( # ) key. You will hear a short double beep if the programming was accepted and stored in the system.
STEP 5: Prepare System for Operation
• Hang up the programming phone and then place the PROGRAM/RUN switch in the RUN position. The green LED will go out.
Replace the switch lock.
BOGEN
DIGITAL TUNER
Music Source
POWER
PCM
TIM