Specifications

......................
.......................
......................
....................
....................
..................
PCM
TIM
PCM
CPU
PCM
TBM
PCM
ZPM
37
APPENDIX
STEP 1: Assembling Modules PCMTIM to PCMCPU and to PCMZPM (see Illustration above)
• Plug the 6-pin power connector from the PCMCPU module to the PCMTIM module jack (J2). Be sure that the locking
ridge faces header wall. (Green wire to the top.)
• Plug the 26-pin ribbon cable from the PCMCPU module to the PCMTIM module 26-pin connector (J1). Be sure to align
the polarizing tab in slot. (Pin 1 red stripe to the top.)
• Place the modules together and dress the connector cables away from the sheet metal so they will not get pinched.
• Push the two units together while aligning the locking tabs in the PCMTIM module to the locking slots in the PCMCPU
module. Slide the two units until the faces of both units are even.
• Secure the two units together by tightening a screw into the screw clamp tab in the back of the PCMTIM.
• Follow the same steps to add the PCMZPM module(s).
NOTE:
Modules must be assembled,
left to right, in the order shown
here: TIM, CPU, TBM (if necessary)
and ZPM.
LOCKING
TAB
LOCKING
TAB
LOCKING
SLOT
LOCKING
TAB
LOCKING
SLOT
ALIGN
CONNECTORS
SO LOCKING
RIDGE FACES
HEADER WALL
ALIGN
POLARIZING
TAB IN SLOT
SCREW
CLAMP
TAB &
SLOT
Align polarizing tab in slot
Align connectors
so locking ridge
faces header wall.
Ribbon Cable Connector
6-pin Connector
Module Assembly
Completed Assembly