TPU600-G2 Telephone Paging Amplifier Installation and Use Guide Specifications are subject to change.
TPU600-G2 WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Avertissement: pour réduire le risque d’incendie ou de choc électrique, ne pas exposer cet appareil sous la pluie et l’humidité. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus.
TPU600-G2 TPU600-G2 Amplifier Front Panel TPU600-G2 Amplifier Rear Panel Introduction This document describes the Bogen TPU600-G2 Telephone Paging Amplifier. It is a full-featured, wall- or rack-mounted amplifier that provides inputs for a dry-loop, 600-ohm telephone page signal, a background music source, and a low-impedance microphone. Automatic background music mute is provided when making a telephone page.
TPU600-G2 Figure 1: Single Unit Rack Mounting Figure 2: Side-by-Side Mounting Figure 3: Wall Mounting Rack Mounting The TPU600-G2 can be rack-mounted through the use of a single-unit Rack Mount Kit (P/N: NQ-RMK03), which is included. Use the supplied screws to attach the brackets to each side of the amplifier, as shown in Figure 1.
TPU600-G2 Slat Holes Cover Slats Security Cover Figure 4: Installing the Security Cover Input Wiring Connections IMPORTANT: Before making any connections or wiring changes to the amplifier or any equipment connected to the amplifier, make sure that the amplifier is NOT powered on. All signal input and control wiring is made to the pluggable Phoenix type connectors on the rear panel. Music Input An input is provided for the connection of a background music source.
TPU600-G2 Figure 5: Wiring for TEL Input and Microphone Connection Night Ringer Connection Either a standard analog telephone ring signal (90–105V AC, 20–30 Hz) or an external contact closure activates the night ringer function of the amplifier.
TPU600-G2 G G – + MIC INPUT – G + CONTACT TEL RING RING TEL INPUT BAL LINE OUT + – MUSIC INPUT IN G G OUT G BRIDGE G – + NC – + – MUTE G RING R T 70V, 25V, 8-OHM 100-240 VAC + MIC INPUT BAL LINE OUT – G + CONTACT TEL RING RING TEL INPUT + – MUSIC INPUT IN G OUT G BRIDGE + NC – + – MUTE G RING R T 70V, 25V, 8-OHM 100-240 VAC Figure 6: Bridge Inputs Output Wiring Connections All output wiring connections are made to the rear panel.
TPU600-G2 Operation Indicator LEDs POWER ⃝ The green POWER LED illuminates whenever AC power is applied to the amplifier via the power switch on the rear panel. PROTECT ⃝ The red PROTECT LED illuminates when the amplifier encounters a short circuit or an overtemp low-impedance speaker load causing thermal shutdown. CLIP ⃝ The red CLIP LED illuminates whenever the speaker output-signal level approaches its maximum level. This indicator is used when setting volume levels.
TPU600-G2 RINGER VOLUME adjusts the level of the night ringer tone output. The MUSIC LEVEL volume control should first be set to the customer’s satisfaction. When adjusting this level, the CLIP LEVEL indicator should be observed to ensure that the amplifier signal is not distorted. MUSIC MUTE LEVEL adjusts the level of the background music heard during a paging announcement. The fully counterclockwise position provides maximum muting (no background music).
TPU600-G2 Specifications Technical Specifications Power Output . . . . . . . . . . . . . . 600W RMS Frequency Response . . . . . . . 20 Hz to 22 kHz ±1dB Distortion . . . . . . . . . . . . . . . . . Less than 1% Hum & Noise . . . . . . . . . . . . . . (20 Hz to 20 kHz) Music: -54 dB; TEL: -54 dB; MIC:-50 dB Sensitivity . . . . . . . . . . . . . . . . Music: 250 mV; Tel: −14 dBm (170mV); MIC: −50 dBv (3.1mV); E.I.N. −119 dBv Tone Control .
TPU600-G2 Compliance Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
TPU600-G2 NOTES 12
TPU600-G2 www.bogen.
