Instructions / Assembly

ManualsBrandsBolder Innovations ManualsGarden Center2 Hole 5 Gal. Bucket Barrow

BUCKET BARROW

ASSEMBLY INSTRUCTIONS

NOTE: parts included

-wheel -axle -handles(4parts)

-top -front handle brace -washer wedges

-front support -axle brackets -leg brace

-center brace -legs -hardware

axle

front handle brace

front axle brackets

legs

handles

center brace

front support

2 bucket top

leg brace

washer wedge

Tools needed: 1/2” wrench and ﬂat screw driver

Summary of content (4 pages)

PAGE 1
BUCKET BARROW ASSEMBLY INSTRUCTIONS NOTE: parts included -wheel -axle -handles(4parts) -top -front handle brace -washer wedges -front support -axle brackets -leg brace -center brace -legs -hardware Tools needed: 1/2” wrench and ﬂat screw driver axle front handle brace front axle brackets legs washer wedge center brace handles front support 2 bucket top leg brace 1
PAGE 2
Quick tips: For easy assembly, put the entire unit together and hand tighten only. This will allow you to align the holes and the parts easier. After fully assembling the unit, make sure to completely tighten all bolts before using. -2, 2 1/2” bolts are for the back holes on the top. Make sure to use the washer wedge between the handles and top to insure that you will not bend the top when tightening. -2” bolts are for the axle brackets, center brace, front handle brace and legs.
PAGE 3
step 1: Insert smaller handles poles into larger and align the two holes as shown step 2: Place 2” bolts in 3rd hole from handle grips. step 3: Add center brace and front handle brace NOTE: Put the 2” bolts through the center brace, then lay ﬂat with the threads up and then place handles on top. front handle brace center brace step 4: Add legs to the base by aligning the holes on the legs as shown below, then hand tighten bolts. Next, add leg brace with 1/2” lip on the bottom. Use 3/4” bolts.
PAGE 4
step 5: Install the wheel by putting the axle through the wheel hub. Next put the left and right axle brackets on the end of the axle with the axle stops on the out side. Place the axel bracket on the handle holes, (as shown) but only use the front bolts. Turn the Bucket Buddy over to sit on the legs and wheel.