Instructions / Assembly

Install the wheel by putting the axle through the wheel hub.

Next put the left and right axle brackets on the end

of the axle with the axle stops on the out side. Place the axel

bracket on the handle holes, (as shown) but only use the front bolts.

Turn the Bucket Buddy over to sit on the legs and wheel.

axle

axle brackets

Add the front support by taking

two 3/4”

bolts and go through both the front support

and the two holes on the rear of the axle

bracket

Place top on the unit by aligning the holes up on the front support and front holes

on the top, use the 3/4” long bolts. Then align the back holes on the top and holes

on the handles, closest to the grips. Use the 2 1/2” long bolts Make sure to use

the washer wedges between the handles and back holes on the top.

NOTE: MAKE SURE TO HAVE THE FRONT SUPPORT

UNDER THE TOP AND NOT ON THE OUTSIDE.

step 5:

step 6:

step 7:

washer wedge