Operating Guide

9
Fig. 5
Handle
Fig. 6
Bolt
Washer
Wing Nut
Shaft
Housing
Hex Bolt Hole
INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Push the handle down onto the shaft housing (Fig. 5). Make sure
the hex bolt hole faces to the left (Fig. 5).
2. Insert the bolt into the hex bolt hole and push it through (Fig. 6).
Place the washer onto the bolt (Fig. 6). Screw the wing nut onto
the bolt, but do not tighten the wing nut completely (Fig. 6) .
3. Hold the unit in the operating pos
ition (
Fig. 14) and move the
handle to a comfortable location (Fig. 6). Make sure the handle is
positioned beyond the end of the safety label (Fig. 6).
4. Tighten the wing nut until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the wing nut (Fig. 6).
2. Hold the unit in the operating position (Fig. 14) and move the
handle to a comfortable location (Fig. 6). Make su
re
the handle is
positioned beyond the end of the safety label (Fig. 6).
3. Tighten the wing nut until the handle is secure.
Safety Label