Instruction manual

ManualsBrandsBOLEX ManualsProjectorSuper 8 cartridge projector

The film breaks

during

projection.

Poor

splice.

The

cartridge

is

not

changed, and Damaged

perforations

at

the

end

the

film

stops

at the end

of

pro-

of the film.

jection.

The

lens

cover

does

not

close

. Hinge pin

out

of

position

.

13

Immediately press

the

still

projection

key

(-)

to

insertthecatathermic

filter

between lamp and film. Without releasing

the

pressure on

the

key:

- remove

all

the

cartridges

except

the

one being

projected;

- press the key

(+)

to remove the remaining

cartridge

and rewind

the portion

of

film already engaged. If

the

red

warning

light is on,

keep the key ( - ) depressed

until

the

previous film is rewound.

Stop

the

projector

by

closing

the

cartridge

compartment

door.

Open

the

side

cover

(see section

"Maintenance")

and remove the

projected

portion

of

the

film. If it

cannot

be reached, remove the

film

channel

cover

and, if necessary, the

take-up

reel with the

wound-up

film.

Press

immediately

on

the

cartridge

changing

key

(+).

Replace the

hinge

pin

under

the

spring

by lifting the

latter

with

the

blade

of a knife.

Intensive film projection

(demonstration,

training

and

promotional

films)

Films

returned from

developing

are

already

treated to withstand

a certain

number

of

projections

without

deterioration.

However, a

special

protective

treatment

is advisable in the case

of

Super

8

original

films

or

copies

which

will

undergo

intensive

projection.

This

treatment

is carried

out

by specialized

laboratories

for

a

modest

charge.

The

Bolex

Multimatic

being

particularly

suitable

for

the purposes

cif

demonstration,

training

and sales

promotion,

we advise you

strongly

to have

this

special

treatment

applied

to films

which

are

intended

for

frequent

projection.