Instruction manual

Reel with built-in clipping device
Only the angle clip (b) may be used.
Push clip (b) fu lly home.
Cutting the film
Remove the side cover with the film cutter inside (see section
"Maintenance", page 14). Cut the beginning of the film leader. Throw
away the cut off part. There must be at least 1 ft. of leader before
the first splice in the film.
In
addition, the leader must be curved in the same direction as the
film on the reel. If it curves too much or curves in the opposite
direction , give it the correct ourve by sliding it between thumb and
forefinger.
3