User`s manual

SVR-8000S User’s Manual
63
3. Select the Set button next to NTP to enter the NTP settings menu, as shown in Figure 8.
Figure 8. NTP Settings Menu
4. Check the NTP checkbox to enable feature.
5. Set NTP settings:
• Synchronize Every: Time in minutes to synchronize with NTP server.
• NTP Server: IP address of NTP server.
6. Click OK to save and exit menu.
Note: Time synchronization interval has a range of 0-10080ms, normally 7200ms. If the DVR is used on a public
network, you should use a NTP server that has a time synchronization function, such as the server at the National Time
Center (IP Address: 210.72.145.44). If the DVR is setup in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.
Configuring a Remote Alarm Host
With a remote alarm host set, the DVR will send a signal to the host when an alarm is triggered. The remote alarm host
must have the Network Video Surveillance software installed.
To set up a remote alarm host:
1. Enter Network settings menu by clicking Menu > Setting > Network.
2. Select the Advanced tab.
3. Click the Set butt next to Host/Others to enter the Host/Others menu, as shown in Figure 9.