User Manual

Manual Mode / Slave Mode
|
15
Manual Mode
In manual mode the VM-260 is triggered by the camera via the hot-shoe connection.
To select manual mode, press the Mode button so the manual mode indicator is lit.
Slave Mode
The VM-260 has an optical sensor that will trigger the ash when it detects a burst from your master ash.
There are two slave modes to select from:
S1 Mode: When the VM-260 is set to S1 mode, it will re in sync with every ash from the master.
S2 Mode: When set to S2 mode, the VM-260 will ignore one pre-ash and re in sync with the second ash.
This is useful when used with a master ash in TTL mode.