User`s manual

Lens rotation

Dimensions

Before Installation

Make sure the installation position can bear a weight 5 times heavier than the camera you are

about to install.

2 Do not have the cable in an improper place or broken, otherwise, these may cause a fire.

3 When installing the camera, please properly install it.

355

Adjusting the camera direction

1 When the camera is fixed on the ceiling, you can adjust

the camera viewing angle. You can rotate your camera

leftward or rightward (Panning), and can change the slope

of your camera upward or down ward (Tilting).

2 In case of panning, the rotation limit of yourcamera is

set to 355 degree (100 degree clockwise and 255

degree counterclockwise). The rotation is stopped by the

Stopper inside of the camera. For panning control, first

unfasten two screws located on the bottom and rotate in the

direction you want, and then fasten them to fix the camera.

3 In case of tilting, you can change the slope of your

camera from zero to 90 degree. However if the slope angle is under 17 degree, you can

encounter a partial image hide problem. To fix the location after adjusting the tilting angle, use

the Tilt fixing screws. To adjust the focus and zoom of your camera, use the Zoom lever and

Focus lever. When you install the camera on the inclined ceiling or wall, you can

rotate the camera lens to see a correct direction image.

1. Dome Enclosure 2. Lens 3. Three-dimensional Bracket 4. Bracket 5. IR Transmitting Components

6. DIP Switch 7. Zoom Adjusting Lever 8. Focus Adjusting Lever

Parts instruction