Specifications

Sonar Alarms menu with Fish Alarm selected. The check box to the left

is blank, indicating the alarm is turned off.

To turn the fish alarm on

1. Press the ALARM key on the front of the unit or press MENU|MENU and

use ↑ or ↓ to select Sonar Alarms, then press

ENT.

2. Press ↓ to

FISH ALARM|ENT|EXIT.

3. To turn off the alarm, Press the

ALARM key on the front of the unit or

press

MENU|MENU and use ↑ or ↓ to select Sonar Alarms, then press

ENT. Press ↓ to FISH ALARM|ENT|EXIT.

Brightness

See the entry in this section for Screen Contrast and Brightness.

Calibrate Speed

The speed sensor can be calibrated to compensate for inaccuracies. Be-

fore you change the setting, first calculate the percentage that the

speed is off. You will enter this percentage in a moment.

For example, if you figure the sensor is reading 10 percent faster than

actual speed, you will enter – 10 in the calibration window. If the sen-

sor is reading 5 percent slower than true speed, you will enter + 5 in

the window.

Perform your test in relatively calm water free of current, if possible.

(Unless, of course, you are taking the current speed into consideration

when making your calculation.) After you have a correction figure,

here's how to enter it:

1. Press

MENU|MENU|↓ to CALIBRATE WATER SPEED|ENT.

2. Enter the number you calculated earlier: press ↑ or ↓ to change the

first character (+ or –), then press → to move the cursor to the next

number and repeat until the percentage is correct, then press

EXIT.