User`s manual
Using Your VS-510C as a Wireless Manual Flash
|
33
The numbers represent the channel, while the letters represent the group.
A. When using a single ash, set it to the same group and channel as the master.
B. When using multiple ash units, select the same group and channel for all units being used in a
particular light position. For example, if you are using three VS-510C units, you might want to set two
as a main light on 1A, and set the third as a ll light on 1B.
5. If desired, adjust the ash coverage angle by pressing the Zoom button repeatedly.
6. Make sure that the red light on the front of the ash is ashing. This indicates that the unit is ready to re
in wireless TTL slave mode.
Using Your VS-510C as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote ash units manually.
Using the optical slave feature, the VS-510C can be set to re whenever it detects a signal from the master
ash. This works optically—when the VS-510C “sees” another ash ring, it will instantaneously re along
with it.