User Manual

Using Your VS-560C as a Wireless Manual Flash
|
33
groups A through C, and then channel 2, groups A through
C, and so on. The numbers represent the channel, while the
letters represent the group.
A. When using a single ash, set it to the same group and
channel as the master.
B. When using multiple ash units, select the same group
and channel for all units being used in a particular light
position. For example, if you are using three VS-560C
units, you might want to set two as a main light on channel 1, group A, and set the third as a ll light
on channel 1, group B.
5. If desired, adjust the ash coverage angle by pressing the Zoom button repeatedly.
6. Make sure that the red light on the front of the ash is ashing. This indicates that the unit is ready to re
in wireless TTL slave mode.
Using Your VS-560C as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote ash units manually.
GROUP B