User Manual

Using the Manual Flash Mode

1. Press the Mode button repeatedly to cycle through

the ash modes until “M” and the ash output level

indicator show on the LCD. Press the up or down

buttons to set the desired ash output level. The

output level will cycle through in both directions.

2. Set the exposure settings you want to use on your

camera. The highest shutter speed available will be

your camera’s ash sync speed.

3. Take a test shot and check the exposure on your camera’s LCD.

4. Adjust your camera’s exposure settings and the light output level of the ash as needed.

5. Press your camera’s shutter-release button to take the picture.

Note: For best results, a handheld light meter is recommended when using the manual ash mode.

To avoid overheating and damaging your ash unit, please wait for at least 10 minutes after 20 continuous

ashes at full power. The ash will automatically shut off if it gets overheated.