User Manual

32
|
Troubleshooting
Troubleshooting
Problem Solution
The ash is stuck in the camera
hot shoe.
Make sure that the mounting foot lock is released (Page 13).
The ash is turned on but won’t
re.
Make sure that fresh batteries are installed and in the proper orientation
(Page 12).
The ash is set up as a wireless
TTL slave but won’t re.
• Make sure that the master ash is within the transmission range and
the wireless sensor on the slave is pointing toward the master ash.
Remove any obstructions in the line of sight between the two
(Page 30).
• The ambient light may be too high (Page 31).
The ash is set up as a manual
(optical) slave, but the light is not
noticeable in the picture.
Make sure that the ash is set to the appropriate slave mode (Page 29).
The edges of images look dark. Make sure that the ash zoom setting corresponds to the focal length of
your lens (Page 20).