User Manual

20
|
Using the Manual Flash Mode
To apply ash exposure compensation, press the up or down buttons on the ash to increase or decrease
ash exposure by 1/3 stop—up to 3 stops total. The LCD will display EV+ or EV- next to the exposure value to
indicate whether it is increased or decreased.
Using the Manual Flash Mode
You can also set the VS-570N’s ash output level manually for greater creative control over your images.
Seven manual settings are available: 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, and 1/64. The 1/1 setting is the full-power
ash, and each successive setting halves the light
output. To use the manual mode, turn the ash and
camera on and follow these steps:
1. Press the Mode button repeatedly to cycle through
the ash modes until “M” and the ash output
level indicator show on the LCD. Press the up or
down buttons to set the desired ash output level.
The output level will cycle through in
both directions.
M