User Manual
32
|
Setting the Flash Groups
5. Choose the master ash mode. Choose whether to use the VS-570N
as a wireless master in TTL or manual mode. Press the Mode button and
then use the up or down navigation buttons to select TTL or Manual.
6. Set EV or power output for the master ash.
A. In TTL mode, press the Mode button and then use the up or down
navigation buttons to adjust EV from -3.0 to +3.0.
B. In manual mode, press the Mode button and then use the up or
down navigation buttons to set the power output from 1 to 8 (See
Chart on page 30).
Setting the Flash Groups
After conguring the master ash, set the slave ash groups. Just like the master ash, you can turn the group
on, choose TTL or manual, and set EV or power output. Each ash group is set in order from A to C, and all
settings for one group are congured before moving on to the next.
Note: When setting groups on the VS-570N, make sure to set your slave ashes to the corresponding groups.
Be aware of the independent recycling time of each ash to ensure that all ash units are ready to re.
TTL
M
EV+
EV-
6
H
EV+
EV-
5