User Manual

Setting the Flash Groups
|
33
1. Turn the group on or off. After setting EV or power output for the master
ash or previous ash group, choose whether you want the next ash
group to re as part of the exposure. Press the Mode button so the ash
on/off selector and group indicator appear onscreen. Use the up or down
navigation buttons to select on or off.
2. Choose the group’s ash mode. Choose whether you want the group to
re in TTL or manual mode. Press the Mode button and then use the up or
down navigation buttons to select TTL or Manual.
3. Set EV or power output for the group.
A. In TTL mode, press the mode button and then use the up or down
navigation buttons to adjust EV from -3.0 to +3.0.
B. In manual mode, press the mode button and then use the up or down
navigation buttons to set the power output from 1 to 8.
Repeat these steps for all three ash groups.
After setting group C, press the Mode button to return to the wireless master
summary screen. At this point, your VS-570N’s wireless master setup will be
complete, and you will be ready to start shooting.
GROUP A
EV+
EV-
GROUP A
EV+
EV-
GROUP A
EV+
EV-
GROUP A
EV+
EV-
2
1
A
B