User Manual
Using Your VS-570N as a Wireless Manual Flash
|
37
4. Use the up or down navigation buttons to select the channel and
group. The ash will cycle through channel 1, groups A through C; then
channel 2, groups A through C; and so on.
A. When using a single slave ash, set it to the same group and
channel as the master.
B. When using multiple slave ashes, select the same group and channel for all units in the same light
position. For example, if your setup includes three slave ashes, you can set two as a main light on
channel 1, group A, and set the third as a ll light on channel 1, group B.
5. If desired, adjust the ash coverage angle by pressing the Zoom button repeatedly.
6. Make sure that the red light on the front of the VS-570N is blinking. This indicates that the unit is ready to
re in wireless TTL slave mode.
GROUP B