Manual

10/10/2012
(C) 2012 BOLTEK CORP EFM-INV_Instruction_1.2
ELECTROCUTION WARNING:
INSTALLATION OF THIS PRODUCT NEAR POWERLINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS.
FALL WARNING:
DO NOT ATTEMPT INSTALLATION AT HEIGHTS UNLESS YOU ARE EXPERIENCED
IN THE SAFE USE OF LADDERS AND FALL ARRESTING EQUIPMENT. IF UNSURE
REFER INSTALLATION TO AN EXPERIENCED ANTENNA OR SATELLITE INSTALLER.
LIGHTNING ACTIVITY WARNING:
DO NOT WORK ON THE SYSTEM OR CONNECT OR DISCONNECT CABLES DURING
PERIODS OF LIGHTNING ACTIVITY.
Installation and Grounding Warning
Warning Do not locate the sensor near overhead power lines or other electric light or
power circuits, or where it can come into contact with such circuits. When installing the
sensor, take extreme care not to come into contact with such circuits, as they may cause
serious injury or death. For proper installation and grounding of the sensor, please refer to
national and local codes (e.g. U.S.:NFPA 70, National Electrical Code, Article 810, in
Canada: Canadian Electrical Code, Section 54).
Document Revision History
1.0 2009 Original document
1.1 07/31/2011 Added instructions to apply silicone grease to threads and washer