Owner`s manual

１９
C D E F
(B) Saddle strip
Wear on the rear saddle gib strip (A)
may be accommodated by adjustment
of the socket head set screws . A
The procedure for adjustment is
to first release the hexagon nuts (B) B
and turn the socket head set screws(C) slightly
in clockwise and then reclamp the hexagon nuts, C
Care should be taken to avoid over adjustment 45
0
turn at the socket head set
screw approximately 0.125mm (0.05") taken up in the gib.
(C) Cross slide A
Wear on the taper gib strip(B) may be adjusted B
for by clockwise rotation of the slotted head screw(A)
on the front of the cross slide . The procedure is
to first slacken the similar screw at the rear end,
retighten this after adjustment to clamp the gib in its new position.
(D) Toolpost
It is the same procedure as cross slide .
(E) Cross slide nut
Provision is made for the elimination
of back lash in the cross slide nut .
the procedure for adjustment being as follows .
Take off the anti-dust plate which is mounted on the rear face of saddle groove ,
turn the cross traverse handle by clockwise to move the cross feed nut until it reaches