Owner`s manual

２
1.2.9 WEAR PROPER APPAREL
No loose clothing. Gloves, neckties, rings bracelets, or jewelry to get caught in
moving parts. Nonslip footwear is recommended . Wear protective hair covering to
contain ling hair.
1.2.10 ALWAYS USE SAFETY GLASSES
Also use face or dust mask if cutting operation is dusty. Everyday eyeglasses only
have impact – resistant lenses. They are not safety glasses.
1.2.11 SECURE WORK
Use clamps or a vise to hold work when practical. It’s safer than using your hand
and frees both hands to operate tool.
1.2.12 DON’T OVERREACH
Keep your proper footing and balance at all times.
1.2.13 MAINTAIN TOOLS IN TOP CONDITION
Keep tools sharp and clean for best and safest performance. Follow instructions
for lubricating and changing accessories.
1.2.14 DISCONNECT TOOLS FROM POWER SOURCE
Before servicing and when changing accessories such as blades , bits cutters or
when mounting and re-mounting motor .
1.2.15 AVOID ACCIDENTAL STARTING
Make sure switch is in “OFF” position before plugging in cord .
1.2.16 USE RECOMMENDED ACCESSORIES
Consult the owner’s manual for recommended accessories. Use of improper
accessories may be hazardous.
1.2.17 NEVER STAND ON TOOL
Serious injury could occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
1.2.18 CHECK DAMAGED PARTS
Before further use of the tool , a guard or other part that is damaged should be
carefully checked to ensure that it will operate properly and perform its intended
function. check for alignment of moving parts , binding of moving parts , breakage of
parts , mounting , and any other conditions that may affect its operation . A guard or
other part that is damaged should be properly repaired or replaced.
1.2.19 DIRECTION OF FEED