Owner`s manual
６
Metric --------------------------------- 0.025-0.69 mm/rev
Tailstock Quill Diameter ---------------------------------------1-1/4" (32mm)
Travel -------------------------------------------------3-3/4"(95mm)
Taper -----------------------------------------------------------M.T.3
Weights (NW/GW) -------------------------------------------------------869lb/1089lb
(With machine stand) -------------------------------------------------------------1309lb
Packing size (LWH)----------------------------- -----------75.59"*29.92"*29.92"
4.UNLOADING
Unpack the wooden case first and use the bed clamping plates and eyebolts to
sling the lathe. Position the saddle and tailstock along with the bed to keep the
balance. Make sure not to hit the leadscrew, spindle or other long rods and handwheel,
when the machine is unloaded.
4.1Cleaning
Before operation and controls. Remove the anticorrosion coating from all
uncovered machine parts, Use white spirit or kerosene (paraffin). Do not use lacquer
thinner or other caustic solvents. Oil all bright machined surfaces immediately with
lubricating oil after cleaning. Use heavy oil or grease on the change gears.
4.2 Setting up the machine
Locate the machine on a solid foundation, (A concrete floor is the best for the
machine), allowing sufficient area for easy work and maintenance. The machine may
be used when it is free standing, but for maximum performance it should be bolted
down with four M12 foundation bolts. Use an engineers precision level on the
bedways to make further adjustment for level conditions.
4.3 Electrical supply
Power should be supplied through a separate isolator, the input wires are
connected to main terminals at the back of the headstock. Check that the operating
voltage and frequency given on the type plate corresponds to the local mains voltage
and frequency. Connect fuse between the power source and switch, earth with
machine.
Main motor rotation must be clockwise, viewed from the pulley end (spindle must
be anti – clock wise by looking from tailstock end ) . In case that the motor is running
in a wrong direction, interchange any two of the three phase lines.