User Manual

Mobile Camera MG582 4 Advanced Operations
Page 9
1800MHz and 1900MHz.
You should set the right MMS setting parameters. The settings of
MMS: URL, APN, IP and Port. Please contact the network
service provider if you are not familiar with the settings.
MMS Mode
There are 3 MMS modes: “Manual ”works in TEST mode ，
“Daily report”and“Instant”work in ON mode.
1)“Manual”:
Choose“Manual” in Test mode. Please ensure SIM card is
inserted properly; Please note, only photo can be sent in TEST
mode .Video information can’t be sent in TEST mode.
2)“Daily Report”:
Daily Report, just working in ON mode， which means that the
camera will report the summarized information in preset time (if
the preset time is, eg.20:00PM) on how many pictures it had taken
per day. So, you will get a summarized text message with the last
picture taken until 20:00PM.
If it is on Camera mode, the camera will send a MMS at the
preset time. The MMS will show you the latest photo and the total
qty of the pictures get taken. If it is on Video mode, the camera
will send a SMS at the preset time. The SMS will show you how
many video clips the camera has taken within 24 hours.
3) “Instant”:
Instant, just works in ON mode, which means the camera will
send a MMS instantly after it captures a photo or a video clip.
While, for the economy consideration, there is a limitation on the
MMS quantity per day. You can set the MAX number from 0 to
99.
If it is on Camera mode and you chose the Instant MMS mode,
and set the MAX number is 10, the camera will send 10 MMS
within 24 hours .And then it continues to capture photos and save
them in the SD-card. After 24 hours, the camera will send MMS
again when it captures photos. If it is on Video mode, the
Camera will send only SMS instead of MMS.
4) “OFF” : To close MMS function.
Send To
Enter the phone number or email where the MMS to be sent to.
There are maximum four numbers or four emails to be sent at the
same time.
1> Number: press “#”for switch between each input;
2> Email: see 1.3.2 for punctuation information;
3> Both: ensure there is at least one phone number and one
email address.
Password
For the safety sake, enter a password each time when entering Test
mode. The default password is 0000. You could choose OFF to
stop this function.