User Manual

Mobile Camera MG582 4 Advanced Operations
Page 13
4.1.11 Set PIR Sensitivity
This parameter defines the sensitivity of the PIR. There are three parameters:
High, Normal, and Low. The default value is “Normal”. The higher degree indicates
that the Camera is more easily to be triggered by motion, taking more pictures or
recording more videos. It is recommended to use high sensitivity degree in room or
environment with little interference, and to use lower sensitivity for outdoor or
environment with lots of interference like hot wind, smoke, near window etc.
Furthermore, the sensitivity of the PIR is strongly related to the temperature. Higher
temperature leads to lower sensitivity. Therefore it is suggested to set a higher
sensitivity for high temperature environment.
The following shows how to set PIR sensitivity as Low provided that the
previous option is Normal.
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Sense Level.
c) Press LEFT or RIGHT to select Low.
d)
Press OK to save the current setting and the option will be un-highlighted.
Press MENU to cancel setting and return to info display.
4.1.12 Set Timer
This parameter defines a certain time lapse in a day when the Camera can be
triggered. In the rest of the time the device is shut off. The effective value for the
ranges from 00:00：00 to 23:59:59.
Please note that the start and stop time can only be effective when the timer is set
as On. Provided that the camera should work from eight a.m. to five p.m., the steps
are as following:
a) Press MENU to display the setting menu.
b) Press UP or DOWN to select Timer Switch.
c) Press RIGHT to select On.
d) Press OK to enter into submenu.
e) Press RIGHT to select item, press UP or DOWN to change the value until the
start time changes to 8 and the stop time changes to 17.
f) Press OK to save all current setting and the option will be un-highlighted.
Press MENU to return to previous menu.
4.1.13 Set Flash Range
This parameter defines how many IR lights will work when the sunlight is not
enough. If you choose 12m, it means the 34 IR lights will all work. .If you choose 6m,
it means only the outside two lines IR lights will work and the power consumption
will be smaller. The following shows how to set flash range as 6m provided that the
previous option is 12m.
i) Press MENU to display the setting menu.
j) Press UP or DOWN to select Flash Range.
k) Press LEFT or RIGHT to select 20 ft./6m or 40 ft./12m.
l)
Press OK to save the current setting and the option will be un-highlighted.