Specifications

109
Southwestern Industries, Inc.
TRAK LPM Programming, Safety, & Operating Manual
removed from the table, the tool itself will be marked to be removed from the TOOL
LOADING screen, so that the tool can be physically taken out of the ATC.
11.2.3 NOTES
This will take you to the notes page where there are several text boxes that allow you to
enter any notes related to your tool setup or descriptions. These are the same notes that
are also found on the Part / Fixture Management page. Notes are saved within each PT7,
PTM or PTG program.
11.2.4 DISABLE LOC
In the event that one of the tool positions on the ATC becomes unusable (for example,
due to the plastic fingers breaking off), you can use this button to disable the usage of that
particular tool location. This will lock the software out from attempting to either grab a
tool from this position, or putting a tool back into it.
11.3 TOOL PATH
When the TOOL PATH soft key is pressed, the program is processed and the tool path
graphics are displayed.
The Tool Path graphics show the program and tool positions
Most programming errors that would prevent the program from running are detected
when the tool path graphics are selected. For example, if you were to have omitted a