Manualshelf

Specifications

ManualsBrandsBoly Media ManualsDigital CameraUNI CAM 3.1
71727374757677787980
RPM: is the spindle RPM for the event. INC SET will use the RPM of the previous
event.
FIN RPM: is the spindle RPM for the finish cut.
Z Feedrate: is the Z feedrate from Z rapid to Z end in in/min from .1 to 700, or mm/min
from 5 to 17780
XYZ Feedrate: is the milling feedrate in in/min from .1 to 800, or mm/min from 5 to
20320
Fin Feedrate: is the milling feedrate for the finish cut
Tool #: is the tool number you assign
8.8.2 Rectangular Profile
Press the RECTANGLE soft key if you wish to mill a rectangular frame (all corners are
90 degree right angles).
Prompts for the rectangular profile:
X1: is the X dimension to any corner
Y1: is the Y dimension to the same corner as X1
X3: is the X dimension to the corner opposite X1; incremental is from X1
Y3: is the Y dimension to the same corner as X3; incremental is from Y1
Z Rapid: is the Z dimension to transition from rapid to feed
Z End: is the Z dimension at the bottom of the frame; incremental is from the previous
event
Conrad: is the value of the tangential radius in each corner
Direction: is the clockwise (input 1), or counterclockwise (input 2) direction for milling
Tool Offset: is the selection of the tool offset to the right (input 1), offset to the left
(input 2), or tool center--no offset (input 0) relative to the programmed edge and direction
of the cutter movement
# Passes: is the number of cycles to machine to the final depth spaced equally from Z
Rapid to Z End (hint: keep Z Rapid small)
Fin Cut: is the width of the finish cut. If 0 is input, there will be no finish cut
RPM: is the spindle RPM for the event. INC SET will use the RPM of the previous
event.
FIN RPM: is the spindle RPM for the finish cut.
Z Feedrate: is the Z feedrate from Z rapid to Z end in in/min from .1 to 700, or mm/min
from 5 to 17780
XYZ Feedrate: is the milling feedrate in in/min from .1 to 800, or mm/min from 5 to
20320
Fin Feedrate: is the milling feedrate for the finish cut (if programmed).
Tool #: is the tool number you assign
8.8.3 Irregular Profile
Press the IRREG PROFILE soft key if you wish to mill a profile other than a rectangle or
circle. The Irregular Profile event gives you the powerful Auto Geometry Engine to
define a shape made up of straight lines (Mills) and arcs.