Operation Manual

BG30 3 Quick Introductions
Arm status is the work status. If you are in Setting Status,
there are two methods to go to Arm Status: 1 Do not press any
key and wait for 1 minute, the camera will automatically switch
to Arm Status; 2 Use the remote control, press “A”, then it will
go to Arm Status immediately.
After going to Arm Status, if the camera is triggered it will
automatically work.
There are 3 ways the camera will react when it’s triggered:
Only insert TF card: After take photos and it just stores
the images in the TF card but doesn’t send out.
Only insert SIM card: After take photos and it just sends
out via MMS or email but doesn’t store in the TF card.
Both insert TF and SIM card: take photos, store in the
TF card and send out to your phone or your email.
Step5: Check setting parameters
If you can’t get MMS or the camera is not working correctly,
you can Press “OK” button in Setting status. Then it will
show you your MMS settings, Email settings or Camera settings
according to your Send Mode.
10