Operation Manual

BG30 4 Basic use and settings

4.18 Load and remove a wireless sensor

Any 433MHz wireless sensor, such as infrared body sensor,

wireless door magnet, wireless smoke detector etc. can be set as an

alarm sensor of the camera.

Method to load or remove a wireless sensor:

1. Power on the wireless sensor;

2. Enter the Setting Status, press LEFT button and enter the

study code menu. Choose Zone1 or Zone2,press OK button, then

trigger the wireless sensor to check if the sensor is loaded

successfully . When it's successful, there will be a "*”before zone1

or zone2

Setting Status Study Code Menu Study Code Menu

3. When you want to remove the wireless sensor. Please enter

the study code menu, press LEFT button to cancel the “*”. If there

is not a “*” before the zone, it means the sensor has been removed

from the camera.